We offer a wide variety of services and are able to assist you with your custom clean up or maintenance needs. For anything not listed on our website be sure to get in touch with us and we will do our best to assist you with your custom requirements.

Examples of this may be stencilled concrete or pebble-crete where the surface is too rough to allow the scrubbing brushes to contact the surface effectively. In these circumstances it is sensible to use a high pressure cleaner to penetrate the uneven surface and provide a superior clean.

Other applications may include floor/wall junctions, walls, posts and any other area that is too small to be accessed via a scrubber.

Pressure cleaning is ideal for removing mould and mildew from external brickwork.

This solution is then recovered from the floor via the vacuum squeegee system at the rear of the scrubbing machine. Typically the floor is touch dry immediately but will take 5 – 20 minutes to dry out more thoroughly depending on ambient conditions.

By using different chemicals and scrubbing brushes or pads, a range of different surfaces can be treated with varying surface contaminants being removed.

We can scrub raw or sealed concrete, epoxy or vinyl. We have even scrubbed a wooden floor and bitchumen floor cleaning to remove flood damage.

We can also scrub unsealed concrete during the construction process to prepare the surface for sealing treatment.

To provide a thorough scrubbing service we can manually clean in corners, around posts and any other areas the machines can not get into.

We currently use two scrubber types to allow both small and large jobs to be done effectively.

This is a battery powered ride on scrubber which scrubs an 850mm wide path. It is a very nimble machine and can scrub aisles and walkways down to approximately 1m wide.

This unit is very effective at cleaning in tight spaces. It has a side shifting scrubbing deck to allow it to run right up against a wall or underneath the outside edge of pallets in racking. This unit is ideal for using pads over epoxy floors or for smaller concrete areas.

We currently use Tennant 6650 and 6500 ride on sweepers. These are maintained monthly and are kept in optimum running order to provide the best sweeping service possible.

Our sweepers have a side broom to get into edges and the main broom operates under constant vacuum.
This vacuumed air is passed through a panel filter, allowing filtered air to pass out the rear of the machine, minimising any airborne dust.

Depending on the specific job requirement, our operators carry blowers to enable them to remove litter and debris from hard to reach areas such as behind parking bollards or posts, etc. This way we can ensure to leave the areas looking as neat and clean as possible.

Why conduct regular sweeping?
Why use a professional service rather than buy / rent own equipment?